Papers by Author: R. Yousefi

Abstract: Prediction of shear plane angle is a way for prediction of the mechanism of chip formation, machining forces and so on. In this study, Merchant and Lee-Shaffer theories are used for prediction of shear plane angles and cutting forces in machining of Al/SiC_p MMC with 20% of SiC as reinforcement particles. The experimental cutting forces are compared with the calculated cutting force based on shear plane angles extracted from Merchant and Lee-Shaffer theories. The variation of these cutting forces with cutting speed, feed rate and depth of cut has been discussed. The results showed that Merchant theory may be used as a good method for prediction of chip formation in machining of Al/SiC_p MMC.

Abstract: Metal matrix composites (MMCs) have received considerable attention due to their excellent engineering properties. Accuracy and surface finish play an important role in modern industry. Undesired projections of materials, known as burrs, reduce the part quality and negatively affect the assembly process. In this study, reducing burr size in drilling of MMC is performed by adding ultrasonic vibration to the process. Al/SiC_p MMC with 5 wt% of SiC particulates in dry drilling operation with HSS drill tools coated with TiN was investigated. The effect of ultrasonic assistance on burr size was studied. The results demonstrate that under suitable ultrasonic vibration conditions, in comparison with the conventional drilling, the burr height and width could be reduced.

Abstract: Prediction of shear plane angle is a way for prediction of the mechanism of chip formation, machining forces and so on. In this study, Merchant and Lee-Shaffer theories are used to predict the shear plane angles and cutting forces in machining of Al/SiC_p MMC. The experimental cutting forces are compared with the calculated cutting force based on shear plane angles extracted from Merchant and Lee-Shaffer theories. The variation of these cutting forces with cutting speed, feed rate and depth of cut has been discussed. The results show that Merchant theory may be used as a good method for prediction of chip formation in machining of Al/SiC_p MMC.

Abstract: Metal matrix composites (MMCs) have received considerable attention due to their excellent engineering properties. However, poor machinability has been the main deterrent to their substitution for metal parts. The hardness and abrasive nature of reinforcement phase causes rapid tool wear during machining which results in high machining costs. In this study, the effect of SiC particles (5, 15 & 20 percent) on tool wear in turning process is experimentally investigated. Continuous dry turning of Al/SiC particulate metal matrix composite produced by powder metallurgy and utilizing titanium carbide inserts has been achieved as the test method. The influence of machining parameters, e.g. cutting speed, feed rate and depth of cut on tool wear and cutting forces were investigated during the experiments. The results show that tool wear increases with increasing cutting speed, depth of cut and feed rate. The cutting speed and depth of cut are more dominant factors compared to feed rate on the tool wear. In addition, it is concluded that the flank wear increases with the increase of SiC percentage in the MMC.