p.3
p.7
p.13
p.18
p.22
p.26
p.29
p.33
Calculation and Analysis of the Interference Amount in Gear Slicing
Abstract:
For the problem of the interference between the machining tooth surface and the major flank face, the calculation method of the interference amount is put forward. The interference amount is defined as the distance of the points on the machining tooth surface to the major flank face. The position of the tooth surface and the major flank face is judged using the model of the tooth surface and the major flank face. So the model of interference amount is get. On this basis, impact law of cutter parameters and machining parameters on interference amount is analyzed. As a result the evidence for the reasonable selection of cutter parameters and machining parameters is provided.
Info:
Periodical:
Pages:
7-12
Citation:
Online since:
November 2014
Authors:
Price:
Permissions:
Сopyright:
© 2014 Trans Tech Publications Ltd. All Rights Reserved